Manual

SYMPTOM POSSIBLE CAUSE
Although a fresh battery has been fitted, the
Etek3 will not switch on.
The battery does not seem to last very long.
The Etek3 leaks from the solenoid.
The Etek3 leaks down the barrel.
Gas vents quickly down barrel as soon as it
is gassed up.
The battery has been fitted incorrectly.
The battery connector is not making proper
contact with the battery.
The battery type is of a low quality.
Either gasket is damaged and/or not seated
correctly in its designated pocket in the
manifold body.
Damaged Etek3 solenoid.
LPR is supercharging causing intermittent
leaking.
Solenoid Spool shaft is damaged or dirty.
Damaged or incorrect seals on rammer.
It is leaking from the barbs.
Leaky exhaust valve.
Damaged rammer housing.
Incorrect seal on front of rammer housing.
The exhaust valve has become jammed in
the rammer housing.
Fit the battery correctly.
Remove the battery, check the battery
connector is clean and re-install the battery.
Use an alkaline or lithium battery. Do not
use a low quality or rechargeable battery.
Replace the gasket if damaged using
Etek3 parts kit. Ensure the gasket is seated
correctly.
Replace Etek3 solenoid.
Clean LPR piston seal.
Inspect regulator seal (in LPR piston) and
regulator seat (in LPR body). Replace if
necessary.
Clean or replace if required.
Replace seals.
Check hose for cuts or replace barbs.
Replace exhaust valve.
Replace rammer housing and o-rings.
Replace front seals on rammer housing with
014 NBR70.
Replace exhaust valve and rammer housing
as necessary (see Maintenance section).
SOLUTION
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
77.
FAULT FINDING
FAULT FINDING
QUICK GUIDE