Manual

CONTINUED
Take the Emortal Board Navigation Console and peal o
the sticker backing. SEE FIGURE 26.7
Making sure the small plastic lens is still in the window
at the bottom of the Navigation Console, and the push
button strip is still in the back of the frame, insert the
Navigation Console into the back of the frame with the
window at the bottom. SEE FIGURE 26.8
Ensure the circuit board retainers are attached in the
correct orientation to the Emortal board SEE FIGURE
26.9.
Then insert the Emortal board into the frame with
the screen at the bottom of the frame.
Connect the BBSS, Solenoid and Trigger connectors to
the circuit board with their corresponding sockets on the
board. SEE FIGURE 26.10
Install a 9V battery as described on page 10. SEE FIGURE
26.11
Replace the three grip screws using a 5/64 hex key. SEE
FIGURE 26.12
You have now installed the Etek3 Emortal board.
FIG 26.8
FIG 26.9
FIG 26.11
FIG 26.7
FIG 26.10
FIG 26.12
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
8081
WARNING
ETEK3
EMORTAL
BOARD
ORIENTATION
76.
UPGRADING