Manual
INSTALLING THE
EMORTAL BOARD AM
AND UPGRADE METAL LT
FRAMES ONLY
Open up the frame by unscrewing the three grip screws
with a 5/64” hex key. SEE FIGURE 26.1
Unplug all 3 connectors from the circuit board. SEE
FIGURE 26.2
Unplug and remove the battery. Seep page 10 on ‘Installing
a 9V Battery’ for instructions on how to do this. SEE
FIGURE 26.3
Slide the LED board out of the frame along with the
retainers. SEE FIGURE 26.4
Using a hex key or nger push the LED navigation console
out of the frame from the back though the window in the
frame SEE FIGURE 26.5. Leave the plastic push button
strip in the back of the frame. SEE FIGURE 26.6
FIG 26.2
FIG 26.3
FIG 26.5
FIG 26.1
FIG 26.4
FIG 26.6
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
75.
UPGRADING
UPGRADING
QUICK GUIDE