Manual
INSTALLING THE LT
UPGRADE KIT
The Etek3 LT can be upgraded to an all metal Etek3 by
purchasing the ‘Etek3 LT Upgrade Kit’.
On the following pages are instructions on how to install
these parts.
INSTALLING THE FEED NECK
Remove the loader from the Etek3 SEE FIGURE 23.1.
Remove the retaining screw from the feedneck using a
5/32” hex key SEE FIGURE 23.2.
With the retaining screw removed, slide the feedneck o
the Etek3 body SEE FIGURE 23.3.
Loosen the retaining screw on the new metal feedneck
with a 5/32” hex key, then slide this onto the Etek3 body
SEE FIGURE 23.4.
Line up the feedneck with the screws towards the back
of the Etek3 SEE FIGURE 23.5 and tighten the retaining
screw at the bottom of the feedneck. This clamps the
feedneck to your Etek3 SEE FIGURE 23.6.
You have now attached your new metal feed neck.
FIG 23.2
FIG 23.3
FIG 23.5
FIG 23.1
FIG 23.4
FIG 23.6
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
72.
UPGRADING