Manual

CONTINUED
Clean and check the condition of the single internal
006 NBR90 o-ring in the front of the OOPS insert, replace
if necessary SEE FIGURE 22.5. Lubricate all three of these
o-rings liberally using Eclipse Grease SEE FIGURE 22.6.
Replace the OOPS insert into the OOPS body ensuring
that the o-ring end goes in rst, pushing it into place SEE
FIGURE 22.7
.
Lubricate the narrow end of the OOPS pin with a smear
of Eclipse Grease and push the pin, narrow end rst, into
the OOPS body so that it sits in the OOPS insert and pokes
through the front of the OOPS body SEE FIGURE 22.8.
Screw the OOPS knob back onto the OOPS body until only
a couple of threads are showing SEE FIGURE 22.9.
Reconnect the macroline hose to the tting on the OOPS
body SEE FIGURE 22.10.
You have now successfully cleaned and maintained your
On/O purge system.
FIG 22.10FIG 22.9
FIG 22.8FIG 22.7
FIG 22.6
FIG 22.5
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
8081
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
71.
MAINTENANCE
MAINTENANCE
QUICK GUIDE