Manual

THE ETEK3 ON/OFF PURGE
SYSTEM OOPS
Having disconnected the macroline hose from the tting
on the OOPS body, unscrew the OOPS knob from the
OOPS body SEE FIGURE 22.1. Clean o any dirt, debris or
moisture from the OOPS knob and the threaded section of
the OOPS body.
Use an appropriately sized hex key to push the OOPS pin
out of the OOPS body SEE FIGURE 22.2 and then remove
the OOPS insert using a pair of needle nosed pliers SEE
FIGURE 22.3.
Clean and check the condition of the two 008 NBR70
o-rings on the outside of the OOPS insert, replacing as
necessary SEE FIGURE 22.4.
FIG 22.2
FIG 22.3
FIG 22.1
FIG 22.4
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
70.
MAINTENANCE