Manual

SWITCHING ON THE ETEK3
EMORTAL BOARD
To switch on the Etek3 press and hold the button until
the screen lights up and the Emortal board begins its
power up sequence FIGURE 2.1.
1,2
SWITCHING OFF THE
ETEK3 EMORTAL BOARD
Press and hold the button until the display shows TURN
OFF.
Release the button and re-press it to turn o the
Etek3.
FIRING THE ETEK3
If the Break Beam Sensor System (BBSS) is disabled, pull the
trigger to re the Etek3. If the Break Beam Sensor System is
enabled and there is a paintball in the breech, pulling the
trigger will also re the Etek3. The entire ring sequence is
controlled electronically by the Etek3 Emortal board and
solenoid, enabling any user to achieve high rates of re
easily.
THE ETEK3 EMORTAL
BOARD
There are three sockets on the Etek3 circuit board, the BBSS
connector (A), the Etek3 solenoid connector (B) and the
micro-switch connector (C) SEE FIGURE 2.2.
1
When the Etek3 is turned on, the Break Beam Sensor System
is automatically enabled.
2
By continuing holding down the button when turning
on the Emortal board the software version number will be
displayed.
FIG 2.2
FIG 2.1
C
A
B
WARNING: THE BACKLIGHT ON THE LCD DISPLAY
TURNS OFF AFTER A PERIOD OF TIME. WHEN THIS
HAPPENS THE MARKER IS STILL ON AND ABLE TO FIRE.
SEE PAGE 49 ON ADJUSTING THE BACKLIGHT
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
7.
QUICK SET-UP
QUICK SET-UP
QUICK GUIDE