Manual

CONTINUED
Inspect the sealing face of both the rammer housing SEE
FIGURE 21.7
and the exhaust valve SEE FIGURE 21.8 for
any excessive wear or damage. If either the exhaust valve
or the rammer housing are damaged then replace with
authentic Etek3 parts.
Clean and lubricate all of the o-rings on the rammer
housing with Eclipse Gun Oil paying particular attention
to the front two around the outlet port on the rammer
housingSEE FIGURE 21.9.
Insert the rammer housing back into the Etek3 body
ensuring that the outlet port is facing upwards and the
valve plug hole is facing downwards SEE FIGURE 21.10.
Slide the rammer housing all the way into the Etek3 body
until the rammer cap nears the back of the body.
Looking on the underside of the Etek3 body carefully
line up the hole in the body and rammer housing which
accommodates the valve plug screw SEE FIGURE 21.11.
Then take a 1/8” hex key and replace and tighten down the
valve plug screw SEE FIGURE 21.12.
FIG 21.9
FIG 21.10
FIG 21.7
FIG 21.11
FIG 21.8
68.
MAINTENANCE