Manual

MAINTAINING THE VALVE
ASSEMBLY
Lift the bolt pin and slide the bolt out of the rear of the
marker. Disconnect any hosing and unscrew the inline
regulator from the front regulator mount as detailed in the
Cleaning the Inline Regulator section of this maintenance
guide (page 54-55). Remove the frame as detailed on page
61.
Take the Etek3 body and turn it so that the underside
of the solenoid assembly, and valve plug are visible and
accessible. Using a 1/8” hex key remove the screw from
the front regulator mount that holds the LPR body in the
marker body SEE FIGURE 21.1.
Remove the entire LPR assembly, the valve spring and
the exhaust valve from the marker body SEE FIGURE
21.2
. Using a 1/8” hex key remove the valve plug from
the underside of the Etek3 body SEE FIGURE 21.3. The
bottom of the rammer housing should now be visible
through the valve plug hole SEE FIGURE 21.4. Ensure that
the rammer is in its rear position and taking an L-shaped
hex key, place it down through the bolt slot in the top of
the body so that you can apply light pressure to the end of
the rammer and push it backwards along with the rammer
housing out the back of the Etek3 body SEE FIGURE 21.5
AND 21.6
.
FIG 21.3 FIG 21.4
FIG 21.2
FIG 21.5
FIG 21.6
FIG 21.1
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
67.
MAINTENANCE
MAINTENANCE
QUICK GUIDE