Manual

THE ETEK3 TRIGGER
ASSEMBLY
Having removed the trigger frame completely from the
Etek3 body (see page 63), remove the retaining clip that
holds the bearing carrier in place in the top of the frame,
this is best done using some pointed nose pliers to pinch
the clip and lift free from the frame SEE FIGURE 19.1.
Gently lift the bearing carrier and trigger assembly free
from the frame taking care not to damage the micro-switch
SEE FIGURE 19.2.
Using a 1/16” hex key, loosen the trigger pin retaining set
screw in the back of the trigger SEE FIGURE 19.3. Use a
small hex key to push the trigger pin out of the bearing
carrier from one side SEE FIGURE 19.4.
Clean the trigger and bearing carrier thoroughly and also
clean the space within the frame that the trigger sits into.
FIG 19.2 FIG 19.3
FIG 19.1
FIG 19.4
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
63.
MAINTENANCE
MAINTENANCE
QUICK GUIDE