Manual

CONTINUED
To re-attach the frame follow the instructions below.
Carefully thread the solenoid and break beam sensor
system wires through the access holes in the top of the
Etek3 grip frame SEE FIGURE 18.5 and re-attach the grip
frame to the marker body by tightening the two grip frame
screws using a 1/8” hex key SEE FIGURE 18.6.
Ensure that the break beam sensor system cables lie neatly
in the slots provided for them on the inside of the Etek3
grip frame and connect the solenoid and the break beam
sensors to their relevant connections on the Etek3 circuit
board SEE FIGURE 18.7. Adjust both the solenoid wires
and the break beam sensor system wires so that they sit
neatly within the grip frame away from the micro-switch
arm SEE FIGURE 18.8.
Re-attach the Etek3 rubber grips to the frame by using a
5/64” hex key to replace the 6 grip screws.
FIG 18.6
FIG 18.7
FIG 18.8
FIG 18.5
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
8081
WARNING
62.
MAINTENANCE