Manual

CLEANING AND
LUBRICATING THE BOLT
Raise the bolt pin and remove the bolt and bolt pin from
the Etek3 marker body FIGURE 17.1.
Using a dry cotton bud remove any paint or grease from
the surface of the bolt SEE FIGURE 17.2.
Lubricate the detent slots on either side of the bolt with
gun oil, ensuring that a drop of oil is placed on the o-rings
at the point where they cross the detent slots SEE FIGURE
17.3.
Replace the bolt, locking the bolt pin into the
designated slot in the rammer using the dot on the bolt as
a reference guide SEE FIGURE 17.4.
We recommend the use of Eclipse Gun Oil on the Etek3
rammer and bolt.
FIG 17.2
FIG 17.1
FIG 17.3
DOT
FIG 17.4
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
WARNING
60.
MAINTENANCE