Manual
CONTINUED
Lubricate all of the seals on the rammer shaft and inside
the rammer cap and replace the rammer into the rear of
the Etek3 body as shown in SEE FIGURE 16.7.
DO NOT use Eclipse Grease on the rammer. Only use light
paintgun oil, we recommend Eclipse Gun Oil.
Replace the rammer cap, using the 3/16" hex key to secure
it into the Etek3 body SEE FIGURE 16.8.
DO NOT over tighten the rammer cap screw.
Noting the position of the rammer in the Etek3 body SEE
FIGURE 16.9,
replace the bolt and locate the bolt pin into
the designated groove in the rammer shaft using the dot
on the bolt as a reference guide SEE FIGURE 16.10.
1
The number of o-rings on the rammer may vary according to
the model of Etek3 that you have.
FIG 16.7
FIG 16.8
FIG 16.9
FIG 16.6
DOT
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
8081
WARNING
FIG 16.10
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
59.
MAINTENANCE
MAINTENANCE
QUICK GUIDE