Manual

MAINTAINING THE
RAMMER
Pull the bolt pin upwards so that it disengages the rammer,
allowing the bolt to be removed via the rear of the Etek3
SEE FIGURE 16.1.
Using a 3/16" hex key, unscrew and remove the rammer
cap at the rear of the Etek3 SEE FIGURE 16.2.
Raise the front of the Etek3 and tap the Etek3 onto your
hand until the rammer falls into the palm of your hand
SEE FIGURE 16.3.
Thoroughly clean the rammer shaft and all of its seals
1
,
paying special attention to the 009 NBR 70 o-ring on the
middle of the shaft SEE FIGURE 16.4), the rear 011 NBR 70
o-ring SEE FIGURE 16.5 and the condition of the rammer
bumper cushion in the rammer cap SEE FIGURE 16.6
OVERLEAF.
Replace any worn seals/bumpers using authentic Eclipse
Etek3 spare parts.
FIG 16.3
FIG 16.5
FIG 16.4
FIG 16.1
FIG 16.2
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
58.
MAINTENANCE