Manual

CLEANING THE LOW
PRESSURE REGULATOR
LPR
1
The inline regulator can be removed if needs be.
Unscrew the LPR cap from the marker body
SEE FIGURE 11.1.
Remove the LPR piston and rear spring from the LPR cap
SEE FIGURE 11.2.
Cupping the palm of one hand, turn the LPR cap upside
down and tip the front spring out into your palm SEE
FIGURE 11.3.
Remove the rear spring from the LPR piston and using a
dry cotton bud, carefully clean the 013 NBR 70 o-ring on
the LPR piston SEE FIGURE 11.4. If the seal is damaged
then replace it. Once the seal has been cleaned, lubricate
with a light application of Eclipse Grease so that it is ready
for re-assembly.
FIG 15.2
FIG 15.4
FIG 15.3
FIG 15.1
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
56.
MAINTENANCE