Manual

CONTINUED
Thoroughly clean the two 008 NBR 70 o-rings
2
on the
adjuster screw and lubricate ready for re-assembly. Inspect
the top face of the adjuster unit for any excessive wear or
damage as this could cause the inline regulator to creep
SEE FIGURE 14.6.
Also inspect the inline regulator piston
sealing face, if this is worn or damaged this can also cause
the regulator to creep or “supercharge.
With the threaded section towards to the base of the
regulator body, re-insert the adjuster screw into the
bottom half of the regulator body SEE FIGURE 14.7.
Apply light pressure to the top of the adjuster screw and
using a 1/8" hex key wind the adjuster screw counter-
clockwise until it stops at the base of the regulator body.
Turn the adjuster screw 4 turns in a clockwise direction to
set the inline regulator pressure at approximately 160 psi.
Take the piston and spring and clean the seal at the top of
the piston
2
, re-lubricating it with a light smear of Eclipse
Grease ready for re-assembly SEE FIGURE 14.8. Insert the
piston and spring into the top half of the inline regulator
body SEE FIGURE 14.9.
The spring in the Etek3 Inline Regulator has been designed
specically for the Eclipse Etek3. Using any other spring
will damage the Etek3 and void your warranty.
Keeping the top half of the inline regulator upside down,
screw the two halves of the inline regulator together SEE
FIGURE 14.10.
You have now stripped, cleaned, lubricated and assembled
your inline regulator.
1
The internals of your inline regulator may vary according to
the model of Etek3 that you have.
2
If any O-rings are damaged then replace them.
Extra o-rings are available in parts kits available online at
WWW.PLANETECLIPSE.COM
FIG 14.6
FIG 14.7
FIG 14.9
FIG 14.8
FIG 14.5
FIG 14.10
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
8081
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
55.
MAINTENANCE
MAINTENANCE
QUICK GUIDE