Manual
CLEANING THE BREAK
BEAM SENSOR SYSTEM
Undo the retaining screw for the break beam sensor cover
on the left hand side of the Etek3 using a 5/64" (2mm) hex
key SEE FIGURE 13.1.
Remove the sensor cover to expose the back of the break
beam sensor unit SEE FIGURE 13.2. Using a dry cotton
bud, carefully remove any debris, paint or moisture from
the back of the sensor unit and from inside the sensor
cover.
Lift the BBSS free from the Etek3 body and using another
dry cotton bud, remove any grease or debris build-up from
the front of the sensor unit SEE FIGURE 13.3.
FIG 13.2
FIG 13.1
FIG 13.3
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
WARNING
52.
MAINTENANCE