Manual

ROF CAP
THE RATE OF FIRE CAP PARAMETER
The ROF CAP parameter is used to specify
whether or not the Etek3 should have a
limited, or capped rate of re. When the ROF
CAP
is enabled, the maximum achievable
rate of re is set by the MAX ROF parameter.
Choices for the ROF CAP parameter are:-
> OFF: Rate of Fire only limited by the loader.
> ON: Rate of Fire limited to the MAX ROF
parameter value.
> CANCEL: Cancel editing and leave the
parameter unchanged.
If the
ROF CAP is switched on, then the MAX ROF parameter
will feature as an item in the Set-Up Menu. If the ROF CAP
is switched o, the MAX ROF parameter is redundant and
omitted from the Set-Up Menu.
MAX ROF
THE MAXIMUM RATE OF FIRE
PARAMETER
The MAX ROF parameter is used to set the
maximum achievable rate of re from the
Etek3. The value of this parameter can be
adjusted between 4.0 and 22.0 balls per
second in 0.1bps increments.
The
MAX ROF parameter will only be displayed
if you have set the ROF CAP parameter to ‘ON’.
46.
EMORTAL BOARD
46.
EMORTAL BOARD