Manual

The remaining set up parameters are used to congure the
performance of the Etek3.
DWELL
The DWELL parameter controls the
amount of time that the solenoid is
energised and therefore the amount of
gas that is released with each shot.
The DWELL parameter is indicated by a
purple light on the Navigation Console
when you are in the SET UP mode.
This parameter is fully adjustable between 1.0ms and
15.0ms in 0.1ms increments.
DEBOUNCE
The DEBOUNCE parameter is used to
set the level of Debounce (anti trigger
bounce) on your Etek3.
The DEBOUNCE parameter is indicated
by a ‘light blue’ light on the Navigation
Console when you are in the SET UP
mode.
This parameter is fully adjustable between Debounce 1
and Debounce 10 with a higher value reducing the amount
of trigger bounce.
THE BALL
DETECTION TIME
The BALL DETECTION TIME parameter
denes how long a paintball has to sit
in the breech of the Etek3 before it is
considered ready to re.
The BALL DETECTION TIME parameter
is indicated by a yellow light on the
Navigation Console when you are in
the SET UP mode.
This parameter is fully adjustable between 1 ms and 10 ms
in 1 ms increments.
THE RESET
PARAMETER
Whilst in SET UP MODE, it is possible
to reset all of the control parameters
to the factory default settings in the
following way:
1. Push and hold the Lock button for
two seconds.
2. The “E”, “G” and “O” on the Navigation
Console will repeatedly ash blue to indicate that the
factory default settings have been restored.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
31.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE