Manual

UNDERSTANDING THE
BBSS OPERATION
The Etek3 displays the status of the Break Beam Sensor Sys-
tem using the ‘E’ area of the Navigation Console as follows:
Any changes to the Breech Sensor Status will be displayed
immediately. This provides valuable feedback to the user.
An example of this is when you are shooting a string of shots
with the BBSS enabled, the “E” on the Navigation Console
will alternate in colour from Yellow (no paintball detected)
to Light Blue (paintball detected). In this instance too much
yellow would indicate that your chosen loader cannot keep
up with how fast you are shooting and is consequently
slowing down your rate of re.
The BBSS is able to switch itself o in the event that a
blockage or contamination prevents it from functioning
correctly. This is represented by a fast ashing purple light
in the “E” area of the Navigation Console. The Etek’s ROF will
be capped at 7.5bps. In this instance, the BBSS will switch
itself back on once the blockage is cleared and the correct
operation of the BBSS can then be resumed
THE BATTERY LEVEL
INDICATOR
The Etek3 displays the status of the battery using the ‘G’
area of the Navigation Console. When the battery is fresh ‘G’
LED ash green.
As the battery is drained the ‘G’ LED will change colour
from green to yellow.
When the battery reaches a level where it will no longer
function reliably, the ‘G’ LED will start to ash red. At this
point the battery must be changed for a new one. For
instructions on installing a new battery see page 10.
INDICATION BREECH SENSOR STATUS
Flashing Yellow
BBSS enabled (On), no paintball
detected - marker will not re.
BBSS enabled (On), paintball
detected - marker will re.
BBSS disabled (O) - marker will
re.
Blockage detected, BBSS
temporarily disabled (O) -
marker will re.
Flashing Light Blue
Flashing Purple
Fast Flashing Purple
26.
USING YOUR ETEK3