Manual

THE TOURNAMENT LOCK
The Etek3 has an electronic tournament lock which, once
enabled, prevents the user from making any changes to
the setup parameters of the marker. This tournament lock
complies with the rules of all major tournaments and must
be enabled prior to entering the eld of play in order to
avoid penalties.
To enable the tournament lock -
1. Unscrew the three screws from the right hand side of the
rubber grips SEE FIGURE 10.1 using a 5/64” hex key.
2. Turn on the Etek3.
3. Locate and press the Lock button on the circuit board
SEE FIGURE 10.2. The Navigation Console will ash green
to indicate that the tournament lock has been enabled.
4. Replace the three rubber grip screws using a 5/64” hex
key.
To disable the tournament lock –
1. Unscrew the three screws from the right hand side of the
rubber grips SEE FIGURE 10.1 using a 5/64” hex key.
2. Turn on the Etek3.
3. Locate and press the Lock button on the circuit board
SEE A IN FIGURE 10.2. The Navigation Console will ash
red to indicate that the tournament lock has been disabled.
4. Replace the three rubber grip screws using a 5/64” hex
key.
FIG 10.1
FIG 10.2
A
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
25.
USING YOUR ETEK3
USING YOUR ETEK3
QUICK GUIDE