Manual

ADJUSTING THE VELOCITY
When using your Etek3, you may wish to change the
velocity at which your Etek3 is ring. This is done by
inserting a 1/8" hex key into the adjuster screw at the
bottom of your Etek3 inline regulator and adjusting it
accordingly SEE FIGURE 9.1. By turning this adjuster
screw clockwise you decrease the output pressure of the
inline regulator and consequently the velocity, by turning
the adjuster screw counter clockwise you increase the
output pressure of the inline regulator and consequently
the velocity
1
. On the bottom of the inline regulator there
are engraved arrows to illustrate which direction to turn
the hex key to make the relevant adjustment.
ADJUSTING THE LPR
PRESSURE
When using your Etek3, you may wish to change the
output pressure of your LPR. This is easily done by inserting
a 1/8" inch hex key into the adjuster screw at the front
and adjusting it accordingly SEE FIGURE 9.2. However
we recommend that the LPR screw be left set 2 turns in
(clockwise) from the screw being ush with the front of the
LPR cap.
By turning the adjuster screw clockwise, you decrease the
output pressure of your LPR and consequently reduce the
pressure driving your rammer back and forth. By turning
the adjuster screw counter clockwise, you increase the
output pressure of your LPR and consequently increase the
pressure driving your rammer back and forth.
2
1
After each adjustment re two clearing shots to gain an
accurate velocity reading. Never exceed 300fps.
2
Turning the adjuster screw in too far will prevent the Etek3
from ring.
FIG 9.1
FIG 9.2
24.
USING YOUR ETEK3