Manual
INSTALLING A 9V BATTERY
Ensure that the Etek3 is switched o. Place the marker on a
at surface in front of you with the feed tube furthest away
from you and the barrel pointing to the right.
Using a 5/64” (2mm) hex key, remove the three
countersunk screws that holds the rubber grip onto the
grip frame. Peel the rubber grip to the right to expose the
electronics within the grip frame.
If present remove the existing 9 volt battery by sliding your
thumb into the recess provided below the battery and
lever the battery gently out of the frame SEE FIGURE 4.1.
On top of the battery you will see the battery connector
and wire that is used to connect the battery to the circuit
board. Gently separate the battery connector from the
battery, so that the existing battery can be disposed of
accordingly and taking a new 9 volt Alkaline battery (type
PP3, 6LR61, MN1064)
1
connect it to the battery connector
SEE FIGURE 4.2.
The battery will only connect to the battery connector
one way. If you are unsure of how to install a new battery
please contact your nearest Eclipse Service Centre.
Ensure that all of the wires are within the recess of the
frame and not trapped in micro-switch, then replace the
rubber grip and tighten the countersunk grip screws using
the 5/64
th
” (2mm) hex key.
DO NOT OVERTIGHTEN THE SCREWS.
1
Do not use rechargeable batteries or low quality batteries.
FIG 4.2
FIG 4.1
10.
QUICK SET-UP