Manual

VISIT WWW.PLANETECLIPSE.COM
ORIENTATION
8
VISIT WWW.PLANETECLIPSE.COM
THE ETEK2 CONTROL CONSOLE
At the rear of the Etek2’s grip frame you will find both the Select push
button and three alphabetic LED covers which combine to form the
Etek2’s Control Console. The Control Console is used for several different
purposes including:
- TURNING THE ETEK2 ON AND OFF USING THE
SELECT PUSHBUTTON.
- DISPLAYING THE VALUE OF PARAMETERS USING THE UID.
- SELECTING AND EDITING PARAMETERS USING THE
SELECT PUSHBUTTON.
- DISPLAYING THE BATTERY LEVEL.
- TURNING THE ETEK BBSS ON AND OFF USING THE
SELECT PUSHBUTTON.
INSTALLING A BATTERY
Ensure that the Etek2 is switched off. Place the marker on a flat surface
in front of you with the feed tube furthest away from you and the barrel
pointing to the right.
Using a 5/64
th
” (2mm) hex key, remove the three countersunk screws that
holds the rubber grip onto the grip frame. Peel the rubber grip to the right
to expose the electronics within the grip frame.
If present remove the existing 9 volt battery by sliding your thumb into the
recess provided below the battery and lever the battery gently out of the
frame [SEE FIGURE 2.1].
On top of the battery you will see the battery connector and wire that
is used to connect the battery to the circuit board. Gently separate the
battery connector from the battery, so that the existing battery can be
disposed of accordingly and taking a new 9 volt Alkaline battery (type
PP3, 6LR61, MN1064) connect it to the battery connector (SEE FIGURE
2.2) . Note: The battery will only connect to the battery connector one
way. If you are unsure of how to install a new battery please contact your
nearest Eclipse Service Centre.
Ensure that all of the wires are within the recess of the frame and then
replace the rubber grip and tighten the countersunk grip screws using the
5/64
th
” (2mm) hex key.
DO NOT OVER-TIGHTEN THE SCREWS.
FIG 2.1
FIG 2.2
SELECT BUTTON
TOP LED
MIDDLE LED
BOTTOM LED