Manual

VISIT WWW.PLANETECLIPSE.COM
VISIT WWW.PLANETECLIPSE.COM
39
FAULT FINDING
SYMPTOM POSSIBLE CAUSE SOLUTION
The Etek2 leaks down barrel
Gas vents quickly down barrel as soon as it is
gassed up.
The marker is chopping or trapping paint.
The Etek2 fires yet bolt doesn’t move.
The Etek2 does not fire.
Leaky Exhaust Valve.
Damaged Valve Seat.
Incorrect seal on front of Rammer Housing.
The Exhaust Valve has become jammed in the
brass valve guide.
The Break-Beam Sensor System is switched
off.
The Bolt is dirty, causing the sensor system to
incorrectly detect a retracted bolt.
The Break-Beam Sensor System is dirty
causing the incorrect detection of paintballs.
Bolt pin is not located in Rammer correctly.
Trigger is set up incorrectly.
Solenoid is not plugged into the Etek2 PCB.
The Break-Beam Sensor System is enabled
but there is no paint.
Replace Exhaust Valve.
Replace Rammer Housing.
Replace front seals on Rammer Housing with
016 seals.
Replace Exhaust Valve and brass valve guide
as necessary ( see Maintenance Section ).
Switch on the Break-Beam Sensor System.
Increase the ball detection time.
Clean the Bolt.
Clean the Break-Beam Sensor System.
Lift Bolt pin and line up with position of
rammer correctly ( See Maintenance Section ).
Set trigger up correctly ( See Advanced Set-
Up Section ).
Plug solenoid into port on the Etek2 PCB.
Fill loader with paint / switch off BBSS.