Manual
VISIT WWW.PLANETECLIPSE.COM
MAINTENANCE
34
VISIT WWW.PLANETECLIPSE.COM
...ASSEMBLING THE ETEK2
Carefully thread the solenoid and Break-Beam Sensor leads through the
access hole in the top of the grip frame (SEE FIGURE 5.51), and reattach the
grip frame to the marker, tightening the grip frame screws using a 1/8”
hex key (SEE FIGURE 5.52).
Ensure that the Break-Beam Sensor cables lie neatly in the slots provided
for them in the Etek2 grip frame. Connect the solenoid and the Break-
Beam Sensors into their relevant places on the Etek2 PCB (SEE FIGURE
5.53). Install a 9volt battery by attaching it to the battery connector and
re-attach the Etek2 grips by securing the six grip screws using a 5/64th"
hex key (SEE FIGURE 5.54).
Screw the inline regulator back into the FRM (SEE FIGURE 5.55) and connect
any hosing that was disconnected. Replace bolt and locate bolt pin in the
designated groove in the rammer.
You have now assembled your Etek2.
NOTE: CHECK THAT NO WIRES ARE TRAPPED BEFORE TIGHTENING
DOWN THE FRAME SCREWS.
FIG 5.51
FIG 5.53
FIG 5.54
FIG 5.52
FIG 5.55