Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

Lubricate all of the seals on the rammer shaft and replace the rammer into

the rear of the Etek2 body with the bumper at the back (SEE FIGURE 5.32).

Note: Use light paintgun oiL.

Replace the rammer cap, using the 3/16" hex key to secure it into the

Etek2 body (SEE FIGURE 5.33).

Noting the position of the rammer in the Etek2 body (SEE FIGURE 5.34),

replace the bolt and locate the bolt pin into the designated groove in the

rammer shaft.

FIG 5.29

FIG 5.32

FIG 5.33

FIG 5.34

FIG 5.30

FIG 5.31