Manual

VISIT WWW.PLANETECLIPSE.COM
MAINTENANCE
26
VISIT WWW.PLANETECLIPSE.COM
CLEANING THE LPR
The Inline regulator can be removed if needs be.
Unscrew the low-pressure regulator cap from the Etek2 body (SEE FIGURE
5.18).
Remove the LPR piston and
rear spring from the LPR cap
(SEE FIGURE 5.19).
Cupping the palm of one
hand, turn the LPR cap
upside down and tip the front
spring out into your palm (SEE
FIGURE 5.20.
Remove the rear spring from the LPR piston and using a dry Q-tip, carefully
clean the seal on the LPR piston (SEE FIGURE 5.21. If the seal is damaged,
replace as necessary. Once the seal has been cleaned, lubricate with a
light smear of Vaseline, so that it is ready for re-assembly.
WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED
GAS IN A SAFE DIRECTION, AND REMOVE THE BARREL AND
LOADER TO MAKE THE ETEK2 EASIER TO WORK ON.
NOTE: THE ADJUSTER PISTON (COLOURED CAP THAT THE FRONT
SPRING RESTS IN) DOES NOT NEED TO BE REMOVED FROM THE
LPR CAP FOR REGULAR MAINTENANCE.
FIG 5.18
FIG 5.19
FIG 5.20
FIG 5.21