Manual
VISIT WWW.PLANETECLIPSE.COM
VISIT WWW.PLANETECLIPSE.COM
23
MAINTENANCE
Remove the rubber nger detent and using a dry Q-tip clean the detent
and it’s location point in the Etek2 Body. Replace clean detent back into
the Etek2 body (SEE FIGURE 5.4) and install sensor unit back into place (SEE
FIGURE 5.5).
Replace the Sensor Cover and using a 5/64" hex key, replace the Break
Beam Sensor Cover retaining screw to hold the sensor cover in place
(SEE FIGURE 5.6).
BE CAREFUL NOT TO CROSS-THREAD THE SCREW. DO NOT OVER TIGHTEN THE
SCREW.
Repeat procedure for opposite side of the Etek2.
You have now cleaned your Break-Beam Sensor System.
NOTE: WHEN CLEANING BREAK-BEAM SENSOR SYSTEM INSPECT
CONDITION OF RUBBER FINGER DETENTS AND REPLACE IF
NECESSARY. ENSURE THAT THE RECEIVER SENSOR (INDICATED BY
A RED MARK & RED HEAT SHRINK) IS LOCATED ON THE RIGHT-
HAND SIDE OF THE MARKER BODY.
FIG 5.4
FIG 5.5
FIG 5.6