Manual

VISIT WWW.PLANETECLIPSE.COM
VISIT WWW.PLANETECLIPSE.COM
21
ADVANCED SET-UP
THE MAXIMUM RATE OF FIRE
(BBSS DISABLED).
The Maximum Rate of Fire with the BBSS disabled is used to
control how fast the Etek2 cycles when the Break Beam Sensor
System has been disabled.
The Maximum Rate of Fire (BBSS disabled) Parameter is
displayed by a Blue light on the Control Console when you are
in the Set Up Menu.
This parameter is fully adjustable between 10.0 balls per
second and 15.4 balls per second in 0.1 bps increments.
This parameter should be set to match the slowest speed of the loading
system in use.
DWELL.
The Dwell Parameter controls the amount of time that the
solenoid is energised and therefore the amount of gas that is
released with each shot.
The Dwell Parameter is displayed by a Purple light on the
Control Console when you are in the Set Up Menu.
This parameter is fully adjustable between 1.0ms and 15.0ms in
0.1ms increments.
DEBOUNCE.
The Debounce Parameter is used to set the level of Debounce
(anti-bounce) on your Etek2.
The Debounce Parameter is displayed by a Light Blue light on
the Control Console when you are in the Set Up Menu.
This parameter is fully adjustable between Debounce 1 and
Debounce 10 with Debounce 1 allowing the most bounce and
Debounce 10 the least.
THE BALL DETECTION TIME.
The Ball Detection Time Parameter defines how long a paintball
has to sit in the breech of the Etek2 before it is considered ready
to fire.
The Ball Detection Time Parameter is displayed by a Yellow light
on the Control Console when you are in the Set Up Menu.
This parameter is fully adjustable between 1 ms and 10 ms in 1
ms increments.
THE RESET PARAMETER.
Whilst in Set Up Mode, it is possible to reset all of the control
parameters to the factory default settings in the following way:
1. Push and hold the Lock pushbutton (SEE FIGURE 4.5)
2. The “E”, “G” and “O” on the control will repeatedly flash
blue to indicate that the factory default settings have been
restored.
3. Release the Lock pushbutton.