Manual

VISIT WWW.PLANETECLIPSE.COM

ADVANCED SET-UP

MODIFYING A PARAMETER

You can modify a parameter by using the following guidelines.

1. Ensure that you are in Set Up mode (see previous page).

2. Choose the parameter that you wish to modify.

3. Pull and hold the trigger. The value of the currently selected parameter

is indicated by flashing the three letters on the Control Console as

previously described.

4. When the sequence is complete, the “E” on the Control Console is

illuminated. Release the trigger.

5. Pull the trigger up to nine times to set the tens digit. DO NOT pull the

trigger if the required digit is zero.

6. Push the Select pushbutton. The “G” on the Control Console is

illuminated.

7. Pull the trigger up to nine times to set the units digit. DO NOT pull the

trigger if the required digit is zero.

8. Push the Select pushbutton. The “O” on the Control Console is

illuminated.

9. Pull the trigger up to nine times to set the tenths digit. DO NOT pull

the trigger if the required digit is zero.

10. Push the Select pushbutton. The “E”, “G” and “O” will flash three

times; if the colour is green then the value has been accepted, if the

value is red then the value has been rejected.

If the value is accepted, it will then be saved as the new value for that

parameter.

If the value is rejected, then the parameter will remain unchanged from

how it was before you began modifying it.

Note: To leave a parameter unchanged having already started to modify

it, simply set an illegal value (00.0 or any single digit greater than 9) and

the value will consequently be rejected.