Manual

VISIT WWW.PLANETECLIPSE.COM
ADVANCED SET-UP
18
VISIT WWW.PLANETECLIPSE.COM
THE SET UP MENU
The Set Up Menu can only be entered if tournament lock is off.
To activate the Set Up Menu, firstly ensure that the Etek2 is switched
off. Pull and hold the trigger, and whilst the trigger is still pulled push
and hold the Select pushbutton until the “E” and the “O” on the Control
Console alternately flash white to indicate entry to Set Up mode. When
you have entered the Set Up Menu, the “G” on the Control Console will
turn red to indicate the first parameter of the Set Up Menu: The Firing
Mode. You can now release the trigger.
Press the select pushbutton to scroll through each of the parameters on
the Set Up Menu:
To display a parameter value, pull and release the trigger. The value of the
currently selected parameter is indicated by the “E”, “G” and “O” on the
Control Console flashing in turn, top to bottom. Each letter represents one
digit of the value as follows:
For example a value of 14.5 would be displayed as:
- One flash of the “E”, followed by
- Four flashes of the “G”, followed by
- Five flashes of the “O”.
If a digit is zero then this is represented by no flashes on the area of the
Control Console that represents that digit. For example a value of 3.0
would be displayed as:
- No flashes of the “E”, followed by
- Three flashes of the “G”, followed by
- No flashes of the “O”.
COLOUR PARAMETER RANGE
Red
Green
Blue
Magenta
( Purple)
Cyan
(Light Blue)
Yellow
Firing Mode
Maximum ROF with
Breech Sensor (for capped
modes only)
Dwell
Debounce
Ball Detection Time
1 to 5
10.0 bps to 15.4 bps
10.0 bps to 15.4 bps
1.0 ms to 15.0 ms
1 to 10
1 ms to 10 ms
Maximum ROF without
Breech Sensor