Manual

VISIT WWW.PLANETECLIPSE.COM

USING YOUR ETEK2

ATTACHING A LOADER

Using a 5/32” hex key, turn the top screw of the feed tube counter

clockwise until the feed neck of your loader can easily be pushed into the

top of the feed tube (SEE FIGURE 3.8). Push your choice of loader firmly into

the feed tube so that it rests on the shelf inside the feed tube (SEE FIGURE

3.9). Using a 5/32” hex key, tighten the top screw of the feed tube by

turning it clockwise until the loader is firmly gripped (SEE FIGURE 3.10).

You have now attached a loader to your Etek2. Once you have filled your

loader and air tank you will then be ready to begin using your Etek2.

SWITCHING ON

Pressing and holding the Select pushbutton will switch the Etek2 on.

Release the Select pushbutton when the UID lights up and your Etek2

will begin its power up sequence.

FIG 3.8

FIG 3.9

FIG 3.10