Manual

VISIT WWW.PLANETECLIPSE.COM
USING YOUR ETEK2
12
VISIT WWW.PLANETECLIPSE.COM
INSTALLING AN ADJUSTABLE AIR
SYSTEM
Firstly disconnect the 1/4” Macroline hosing from the elbow attached to
the OOPS at the base of the grip frame (SEE FIGURE 3.4) .
Using a 3/32” hex key loosen the two set screws that tighten the OOPS
body onto the bottom of the grip frame (SEE FIGURE 3.5) . The OOPS
body can now be removed from the T-Slot Rail on the bottom of the grip
frame by sliding it backwards (SEE FIGURE 3.6) to expose the base of
the frame.
As well as the integrated slide rail at the base of the Etek2s grip frame,
there are also two 10-32 UNF threaded screw holes which will accept
standard bottom line screws (SEE FIGURE 3.7) .
Attach the air system of your choice, taking care to use the correct fittings
and length and size of hose to accommodate your requirments.
.
FIG 3.4
FIG 3.5
FIG 3.6
NOTE: WHEN USING AN OOPS ON YOUR ETEK2, THE ETEK2 WILL STILL
HAVE STORED AIR IN THE VALVE CHAMBER, GAS LINE AND INLINE
REGULATOR AFTER YOU HAVE TURNED THE OOPS OFF. PLEASE
REMEMBER TO DISCHARGE THE STORED AIR IN A SAFE DIRECTION AS
YOU ARE UNSCREWING THE ON/OFF KNOB ON THE OOPS.
FIG 3.7