Manual

SYMPTOM POSSIBLE CAUSE SOLUTION
Althoughafreshbatteryhasbeentted,the
Etek Ego will not switch on.
The battery does not seem to last very long.
The Etek Ego leaks from the Solenoid
Thebatteryhasbeenttedincorrectly.
The battery terminals are not making proper
contact with the battery.
The battery type is of a low quality.
Check that gasket is intact and seated
correctly in their designated pockets in the
Minifold.
Dirt on Spool of Etek Ego Solenoid.
Damaged Eclipse Ego Solenoid.
LPR is supercharging causing intermittent
leaking.
Check for damaged or incorrect seals on
Rammer.
Is it leaking from the Barbs?
Fit the battery correctly with the positive
terminal nearest to the side of the frame.
Remove the battery, gently bend the terminals
towards where the battery will sit and then
replace the battery.
Use an alkaline or metal hydride battery. Do
not use a low quality or rechargeable battery.
Replace gasket if damaged using Etek Ego
Parts kit. Ensure gasket is seated correctly.
Stripandcleansolenoid(SeeMaintenance
Section).
Replace Etek Ego Solenoid.
Clean LPR Piston seal.
Inspectregulatorseal(inLPRPiston)and
regulatorseat(inLPRBody).Replaceif
neccessary.
Replace seals.
Check hose for cuts or replace minifold.
SYMPTOM POSSIBLE CAUSE SOLUTION
The Etek Ego leaks down barrel
Gas vents quickly down barrel as soon as it is
gassed up.
The marker is chopping or trapping paint.
TheEtekEgoresyetboltdoesn’tmove.
LeakyExhaustValve.
DamagedValveSeat.
Incorrect seal on front of Rammer Housing.
TheExhaustValvehasbecomejammedinthe
brass valve guide.
TheBreak-BeamSensorSystemisswitched
off.
The Bolt is dirty, causing the sensor system to
incorrectly detect a retracted bolt.
TheBreak-BeamSensorSystemisdirty
causing the incorrect detection of paintballs.
Bolt pin is not located in Rammer correctly.
ReplaceExhaustValve.
Replace Rammer Housing.
Replace front seals on Rammer Housing with
016seals.
ReplaceExhaustValveandbrassvalveguide
asnecessary(seeMaintenanceSection).
SwitchontheBreak-BeamSensorSystem.
Increase the ball detection time.
Clean the Bolt.
CleantheBreak-BeamSensorSystem.
Lift Bolt pin and line up with position of
rammercorrectly(SeeMaintenanceSection).
VIsIT www.PlAneTeclIPse.coM
34
faulT fiNdiNg
VIsIT www.PlAneTeclIPse.coM
35
faulT fiNdiNg