Manual

...assEmbliNg ThE
EgO
Carefully threadthe solenoidand Break-Beam Sensor leadsthrough the
access hole in the top of the grip frame (sEE figurE 5.52), and reattach
thegripframetothemarker,tighteningthegripframescrewsusinga1/8”
hex key (sEE figurE 5.53).
EnsurethattheBreak-BeamSensorcableslieneatlyintheslotsprovided
forthemintheEtekEgogripframe.ConnectthesolenoidandtheBreak-
Beam Sensors into their relevant places on the Etek Ego PCB (sEE
figurE 5.54)
andre-attachtheEtekEgogripsbysecuringthesixgrip
screwsusinga5/64th"hexkey(sEE figurE 5.55).
Screw the inline regulator back into the FRM (sEE figurE 5.56) and
connect any hosing that was disconnected (sEE figurE 5.57). Replace
bolt and locate bolt pin in the designated groove in the rammer.
You have now assembled your Etek Ego.
NOTE: chEck ThaT NO wirEs arE TrappEd bEfOrE
TighTENiNg dOwN ThE framE scrEws.
FIG 5.52
FIG 5.53
FIG 5.54
FIG 5.56
clEaNiNg ThE bOlT
This procedure can be performed with the Etek Ego gassed up as well as
de-gassed.
Raise the bolt pin and remove the bolt and bolt pin from the Etek Ego marker
body.
UsingadryQ-tipremoveanypaintorgreasefromthesurfaceofthebolt
((sEE figurE 5.58).
Replace the bolt, locking the bolt pin into the designated slot in the
rammer.
FIG 5.58
FIG 5.55
FIG 5.57
VIsIT www.PlAneTeclIPse.coM
30
maiNTENaNcE
VIsIT www.PlAneTeclIPse.coM
31
maiNTENaNcE