Manual

assEmbliNg ThE EgO

Having stripped down the Etek Ego, here is a guide of how best to

re-assembleit.

Clean and lubricate the seal at the back of the LPR body (sEE figurE

5.45). Slide the entire LPR back into the Etek Ego body, so that the bottom

of the LPR body lines up with the FRM window in the bottom of the Etek

Ego body (sEE figurE 5.46).

Insert the FRM, ensuring that all of the seals are in the correct place and that

the FRM lines up with the bottom of the LPR body (sEE figurE 5.47).

Usingthe3/16th”hexkeytightendowntheFRMretainingscrewtosecure

both the FRM and LPR in place.

Lubricate the six seals of the rammer assembly (sEE figurE 5.48) and

lubricate the exhaust valve shaft before inserting exhaust valve into the

brass bushed valve guide (sEE figurE 5.49).

FIG 5.45

FIG 5.46

FIG 5.49

NOTE: dO-NOT OvErTighTEN ThE valvE plug

scrEw.

Remembering to include the valve spring, begin to insert the rammer

assembly into the Etek Ego body. By applying slight pressure to the back

of the rammer assembly hold the rammer in place against the exhaust

valve spring tension, so that the valve plug can be replaced (sEE figurE

5.50).

Attach low-pressure hosing to the barb at the back of the FRM (sEE

figurE 5.51)

Continued >

FIG 5.48

FIG 5.47

FIG 5.51

FIG 5.50

VIsIT www.PlAneTeclIPse.coM

maiNTENaNcE

VIsIT www.PlAneTeclIPse.coM

maiNTENaNcE