Manual

clEaNiNg aNd

lubricaTiNg ThE

rammEr

Pulltheboltpinupwardssothatitdis-engagestherammer,allowingthebolt

to be removed via the rear of the Etek Ego (sEE figurE 5.27).

Usinga3/16"hexkey,unscrewandremovetherammercapattherearof

the Etek Ego (sEE figurE 5.28).

Raise the front of the Etek Ego and tap the Etek Ego onto your hand until the

rammer falls into the palm of your hand (sEE figurE 5.29).

Thoroughly clean the rammer shaft and all of its seals, paying special

attention to the seal on the middle of the shaft (sEE figurE 5.30), the

rear seal (sEE figurE 5.31) and the condition of the bumper at the rear

of the shaft (sEE figurE 5.32).

Replace any worn seals/bumpers using authentic Etek Ego spare parts.

warNiNg: dE-gas yOur markEr, dischargiNg

aNy sTOrEd gas iN a safE dirEcTiON, aNd

rEmOvE ThE barrEl aNd lOadEr TO makE ThE

EgO EasiEr TO wOrk ON.

FIG 5.27

FIG 5.28

FIG 5.29

Lubricate all of the seals on the rammer shaft and replace the rammer into

the rear of the Etek Ego body with the bumper at the back (sEE figurE

5.33).

NOTE: usE lighT paiNTguN Oil.

Replacetherammercap,usingthe3/16"hexkeytosecureitintotheEtek

Ego body (sEE figurE 5.34).

Noting the position of the rammer in the Etek Ego body (sEE figurE

5.35), replace the bolt and locate the bolt pin into the designated groove

in the rammer shaft.

FIG 5.33

FIG 5.35

Continued >

FIG 5.32

FIG 5.31

FIG 5.30

FIG 5.34

VIsIT www.PlAneTeclIPse.coM

maiNTENaNcE

VIsIT www.PlAneTeclIPse.coM

maiNTENaNcE