Manual

clEaNiNg ThE lpr

The Inline regulator can be removed if needs be.

Unscrew the low-pressure regulator cap from the Etek Ego body (sEE

figurE 5.19).

Remove the LPR piston and rear spring from the LPR cap (sEE figurE

5.20).

Cupping the palm of one hand, turn the LPR cap upside down and tip the

front spring out into your palm (sEE figurE 5.21).

RemovetherearspringfromtheLPRpistonandusingadryQ-tip,carefully

clean the seal on the LPR piston (sEE figurE 5.22). If the seal is

damaged, replace as necessary. Once the seal has been cleaned, lubricate

withalightsmearofVaseline,sothatitisreadyforre-assembly.

NOTE: ThE adjusTEr pisTON (cOlOurEd cap ThaT

ThE frONT spriNg rEsTs iN) dOEs NOT NEEd TO

bE rEmOvEd frOm ThE lpr cap fOr rEgular

maiNTENaNcE.

warNiNg: dE-gas yOur markEr, dischargiNg

aNy sTOrEd gas iN a safE dirEcTiON, aNd

rEmOvE ThE barrEl aNd lOadEr TO makE ThE

EgO EasiEr TO wOrk ON.

FIG 5.19

FIG 5.21

Insert the front spring into the LPR cap, so that it rests neatly in the adjuster

piston (sEE figurE 5.23).

Place the rear spring onto the LPR piston and insert piston and spring into

theLPRcap,o-ringendrst(sEE figurE 5.24).

BeforescrewingtheLPRcapbackontoyourEtekEgo,useadryQ-tipto

clean the seal inside the LPR body (sEE figurE 5.25). Lubricate this

sealusingalight3in1oil.

Replace the LPR cap by screwing it onto the LPR body in the Etek Ego

(sEE figurE 5.26).

Continued >

FIG 5.25

FIG 5.26

FIG 5.23

FIG 5.24

FIG 5.22FIG 5.20

VIsIT www.PlAneTeclIPse.coM

maiNTENaNcE

VIsIT www.PlAneTeclIPse.coM

maiNTENaNcE