Manual
07
EMEK
FIG-1
A
PUSH SAFE before you begin.
This ensures the marker will not re when the trigger is pulled.
B
Fit the Emek barrel.
Rotate the barrel clockwise into the marker body.
C
Attach a barrel blocking device for safety.
D
Attach the preset air system.
Rotate the air system clockwise into the ASA body.
E
Loosen the PAL clamping feed neck.
Open the feed neck lever away from the feed neck.
Rotate the feed neck lever screw counter-clockwise.
F
Attach the loader.
If the feed neck is too tight, loosen the clamping feed neck more.
If you are attaching a PAL loader, see page 10.
G
Secure the loader.
Close the feed neck lever to secure.
Rotate the feed neck lever screw clockwise to tighten.
H
PUSH FIRE when you are ready to play.
The marker will now re when the trigger is pulled.
1
IMPORTANT! To operate Safety Button see pages 8-9.
2
DO NOT over-tighten the barrel.
3
IMPORTANT! Always ensure marker is de-gassed when setting up.
4
NEVER use CO2. Only use compressed air or Nitrogen.
5
DO NOT over-tighten the feed neck. This may damage the EMEK.
6
IMPORTANT! To attach the PAL loader correctly see page 10.
QUICK START
SETTING UP THE EMEK
WARNING!
Always make sure that the marker is set to PUSH SAFE with a barrel blocking
device installed and that no paintballs are in the EMEK or loader before attaching
an air system.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
Only attach an air system certied for use within the country of use.
Never add lubricants or grease into the ll adaptor of the air system regulator.
Ensure that all screws are tightened and no parts are loose before installing an
air system.
Do not pressurise the EMEK without the bolt system correctly installed, as high
pressure gas will be emitted.
Do not install a compressed air system or load paintballs into the EMEK until
you feel condent with your ability to handle the marker safely and responsibly.
WARNING