Manual
07
MG 100
FIG-1
A
Push the safety button to SAFE before you begin.
B
Make sure the MG 100 is in Magfed mode.
Insert the feedtube plug (see pages 12-13).
C
Connect both parts of the barrel together.
Rotate the barrel tip counter-clockwise onto the barrel back.
D
Attach the complete barrel to the marker.
Rotate the barrel clockwise into the marker body.
E
Attach a barrel blocking device for safety.
F
Ensure the marker is de-gassed.
Push in and hold the POPS button and pull the POPS bonnet away
from the POPS body.
G
Attach the preset air system.
Rotate the air system clockwise into the ASA body.
H
Gas the marker.
Push the POPS bonnet into the POPS body until it engages.
I
Insert magazine into magazine well.
Make sure the magazine clicks securely into place.
J
Push the safety button to FIRE.
The marker will now re when the trigger is pulled.
1
IMPORTANT! To enable SAFE/FIRE see pages 10-11.
2
IMPORTANT! The feedtube plug must be tted correctly for the MG
100 to operate in magfed mode.
3
IMPORTANT! Safety precaution if marker res accidentally.
4
IMPORTANT! Always ensure marker is de-gassed when setting up.
5
NEVER use CO2. Only use compressed air or Nitrogen.
QUICK START
SETTING UP THE MG 100
MAGFED
WARNING!
Always make sure that the marker is in SAFE mode with a barrel blocking device
installed and that no paintballs are in the MG 100 or magazine before attaching
an air system.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
Only attach an air system certied for use within the country of use.
Never add lubricants or grease into the ll adaptor of the air system regulator.
Ensure that all screws are tightened and no parts are loose before installing an
air system.
Do not pressurise the MG 100 without the bolt system correctly installed, as
high pressure gas will be emitted.
Do not install a compressed air system or load paintballs into the MG 100 until
you feel condent with your ability to handle the marker safely and responsibly.
WARNING