Manual

29
MG 100
QUICK START
UNLOADING THE MG 100
HOPPER FED
FIG-1
A
Push the safety button to SAFE before you begin.
B
Attach a barrel blocking device.
C
Ensure the marker is de-gassed.
Push in and hold the POPS button and pull the POPS bonnet away
from the POPS body.
D
Remove the preset air system.
Rotate the air system counter-clockwise from the ASA body.
E
Remove loader/hopper.
Open the clamping feedneck lever to loosen.
Ensure the breech is clear of paintballs.
F
Remove barrel blocking device.
G
Remove the barrel.
Rotate the barrel counter-clockwise from the marker body.
H
Release the dummy magazine.
Pull down the dummy magazine latch to enable its release.
I
Engage and hold the magazine latch.
To release the magazine from the magazine well.
J
Remove the dummy magazine.
Slide the dummy magazine out from the magazine well.
1
ALWAYS always remove rounds from the breech before handling
the marker
2
IMPORTANT! To enable SAFE/FIRE see page 10-11.
3
IMPORTANT! Only remove air system when marker is de-gassed.
4
IMPORTANT! Magazine will not release if magazine latch is not
depressed.
5
IMPORTANT! Keep barrel blocking device attached until safe.
WARNING!
Always make sure the MG 100 is in SAFE mode with a barrel blocking device
attached and that no paintballs are in the breech before unloading.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
NEVER leave the MG 100 gassed up when unloading.
NEVER point your marker in the direction of other people when not on the eld.
Remove any paintballs from the breech before storing your MG 100.
WARNING