Manual

FIG-1
To attach after-market accessories to the shroud sections you must rst
remove and separate both halves of the shroud
A
. Use the 5/32 hex
key to remove the 6 shroud screws
B
rotating counter-clockwise. Then
separate both halves of the shroud.
FIG-2
Attach a third party picatinny rail section
C
by inserting the wingnuts
E
on the inside of the shroud section in the desired position. Mate the
picatinny rail section with the wingnuts and insert the rail screws
D
gently
until they bind with the wingnut threads. Tighten as necessary so they are
secure and will hold the weight of the accessory.
Once complete re-attach the shroud sections in the reverse manner of
Fig-1. You are now ready to attach your accessories (sold separately).
FIG-1
FIG-2
C
A
D
!
!
E
WARNING!
Always ensure the MG 100 is degased and free of projectiles when accessorising.
Make sure shroud screws are fully released before separating the sections as
this could damage the screws and/or the shroud sections.
Do not over tighten any screws as this may damage the screws, shroud
sections or rail sections.
Screw sizes will vary based on the picatinny rail kit manufacturer.
WARNING
5/32
B
21
MG 100
QUICK START
ACCESSORY MOUNTING