Manual

FIG-1
To attach the front shroud and complete the full MG 100 rail kit setup
simply push the front shroud section
A
over the barrel
B
and into the
body section
C
. Check the angle of the connecting sections so it slots
together correctly. Push together rmly so both sections t.
FIG-2
Once the front shroud is connected to the body section insert the shroud
retention clips
D
into the clip retention slots
E
on both sides of the
shroud. These clips ensure both shroud sections are secure.
FIG-3
Once the retention clips
D
are in place the shroud sections are secure.
1
IMPORTANT! The front shroud may not be compatible with third
party barrel systems.
FIG-1
FIG-2
FIG-3
D
D
C
B
E
D
1
!
A
WARNING!
When removing the shroud retention clips DO NOT twist or pull at an angle as
this could damage or even snap the clip stems if too much force is applied.
The shroud sections will not connect if the front shroud section is the wrong
way up.
WARNING
20
MG 100
QUICK START
ATTACHING A
FRONT SHROUD