Manual

16
EMEK
MAINTENANCE
FAULT FINDING TABLES
SYMPTOM POSSIBLE CAUSE SOLUTION
The EMEK leaks from the three-way.
The gasket between the three-way body and gun
body, o-ring on air transfer pipe or the gasket under
the three-way plate are damaged or dirty.
Ensure the gasket is seated correctly.
Replace the gaskets if damaged using EMEK parts kit.
Check condition of the air transfer pipe 010 NBR70 o-ring.
Three-way is over-pressurised.
Check the output pressure of the inline regulator
and adjust accordingly.
Clean and inspect the inline regulator assembly paying
particular attention to the piston tip and regulator seal.
Replace damaged components as necessary.
Damaged or incorrect seals on the three-way spool. Replace and/or lubricate three-way spool seals.
The EMEK leaks down the barrel.
Dirty or damaged can o-rings.
Clean and lubricate or replace 020 NBR70 and
017 NBR o-rings on the front of the can.
Dirty or damaged o-rings on the spool.
Clean and lubricate or replace the 011 NBR70 and
012 NBR70 o-rings on the main spool.
Dirty or damaged bolt o-rings.
Clean and lubricate or replace 14x2 NBR70 o-ring
on the back of the bolt.
Dirty or damaged rear bolt guide o-ring.
Clean and lubricate or replace 14x2 NBR70 o-ring
towards the back of the bolt guide.
The marker is breaking paintballs
in the barrel or breech.
The ball detents are damaged or missing. Replace the ball detents.
The force setting of the loader is too high. Reduce the loader force feed setting.
The paint is poor quality. Try a higher grade of paint.
The velocity is set too high. Check and adjust the velocity of the EMEK.