User Manual

Place the Spring inside the access hole at the rear of
the Cure3+ Bolt and drop a Plunger onto of it so that
the Spring sits inside the body of the Plunger (See
Figure 1.7)
.
Using a 1/8th hex key, push the Plunger suciently so
that the Spring is compressed and the Bolt Pin can be
installed by pushing it into the hole at the top of the
Cure3+ Bolt, until it comes to rest against the hex key
(See Figure 1.8).
Whilst retaining pressure upon the top of the bolt
pin, slide out the hex key. The Bolt Pin should slide
completely through the Bolt as the hex key is removed
(See Figure 1.9).
1
When installing the pin, you should hear it “click”
into place. If this does not happen ensure that the
pin is facing the correct way so that the slot in the
pin engages the Plunger and locks the pin correctly
in place. Rotate the pin as necessary to ensure this
happens.
Noting the position of the Rammer Shaft in the marker
body, replace the Cure3+ Bolt and locate the pin
into the designated groove in the Rammer Shaft as
described in the ‘Cleaning and Lubricating the Bolt‘
section of the ‘Ego10 Operators manual’.
Installation of your Cure3+ Bolt Insert is now complete.
1
Ensure the pin is installed into the top of the Bolt. The top
and bottom of the Bolt are distinguishable by noting the
gas port should be at the bottom of the Bolt.
WARNING: IF YOU ARE AT ALL UNSURE OF
PERFORMING THIS MAINTENANCE PROCEDURE
PLEASE CONTACT YOUR NEAREST SERVICE CENTRE. SEE THE
SERVICE CENTRE CHAPTER OF YOUR EGO10 OPERATORS
MANUAL
(CONTINUED)
Fig 1.7 Fig 1.8
Fig 1.9
FEATURE SUPPLEMENT
9