User Manual

Pull the Bolt Pin upwards so that it disengages the

Rammer and slide the Bolt out from the rear of the

marker as described in the ‘Cleaning and Lubricating

the Bolt’ section of the ‘Ego10 Operators Manual’.

Push the pin back down half way. The pin must be half

way between the fully up (disengaged) and fully down

(engaged) position. Rotate the pin through 90 degrees

so that the Plunger can no longer retain the pin (See

Figure 1.1)

Making sure to cover the back of the Bolt to prevent

the Plunger and Spring falling out prematurely, pull the

Bolt Pin upwards and out of the Bolt (See Figure 1.2). Tip

the Bolt upside down to remove the Plunger and the

Spring from the Bolt (See Figure 1.3).

Take a long blunt tool such as the 1/4” or 3/16” hex key

supplied in your tool tube. Insert the long ball ended

section into the front of the Bolt and gently push the

Bolt Insert out the rear of the Bolt (See Figure 1.4).

Push the desired insert into the back of the bolt,

ensuring that the bolt pin holes in the insert line up

with the holes in the bolt (See Figure 1.5).

If you are installing a Ramped Insert pay particular

attention to the orientation of the insert in relation to

the gas port on the underside of the bolt. Ensure that

the ramp insert does not block this hole o as it will

prevent the SLS from ring (See Figure 1.6).

WARNING: REMOVE ALL PAINTBALLS & DEGAS YOUR

MARKER, DISCHARGING ANY STORED GAS IN A SAFE

DIRECTION, DISCONNECT THE BATTERY & REMOVE THE

BARREL, LOADER & AIR SYSTEM TO MAKE THE MARKER

EASIER & SAFER TO WORK ON.

INSTALLING CURE3+

BOLT INSERTS

Fig 1.1

Fig 1.3

Fig 1.5

Fig 1.2

Fig 1.4

Fig 1.6

FEATURE SUPPLEMENT