User Manual

The Eclipse SLS marker comes with two complete

Trigger Systems (bearing carrier, trigger, spring and set-

screws) that are interchangeable within the SLS frame.

For full details of how to change the Trigger System in

the SLS please consult the ‘Ego10 Trigger Assembly’

section in the ‘Ego10 Operators Manual’. If you have

any doubts about how to conduct this procedure then

do not hesitate to contact your nearest Eclipse Service

Center (see Eclipse Certied Service Center pages of

Ego10 Operators Manual).

For full details of how to adjust your trigger please

refer to the ‘Setting the Trigger Section’ of the ‘Ego10

Operators Manual’.

IMPORTANT

When setting the trigger it is essential to ensure that

the electronic trigger detection is working correctly.

When the trigger is fully depressed the Trigger

Detection Indicator (TDI) should point upwards

. When the trigger is fully released the TDI should

point downwards . For more information, see

‘Understanding the Trigger Detection Indicator (TDI)’

and ‘Filter Menu’ in the ‘Ego10 Operators Manual’.

A Spring

B Spring Return Strength Screw

C Trigger Pin Locking Screw

D Front Stop Trigger Screw

E Magnet Return Strength Screw

F Micro Switch Activation Screw

G Rear Stop Trigger Screw

THE SLS TRIGGER

SYSTEMS

WARNING: REMOVE ALL PAINTBALLS & DEGAS YOUR

MARKER, DISCHARGING ANY STORED GAS IN A SAFE

DIRECTION, DISCONNECT THE BATTERY & REMOVE THE

BARREL, LOADER & AIR SYSTEM TO MAKE THE MARKER

EASIER & SAFER TO WORK ON.

FEATURE SUPPLEMENT