User Manual
Included with the Eclipse SLS marker are two Valve
Guides.
A LP (Low Pressure) Valve Guide which is already
installed inside the SLS, and a HP (High Pressure) Valve
Guide. Both of which will allow you to customize the
set-up and feel of the SLS.
To remove the LP Valve Guide and install the HP version
see the ‘Removing the Valve Assembly’ section of your
‘Ego10 Operators’ Manual. Simply swap over the Valve
Guides during this procedure.
WARNING: REMOVE ALL PAINTBALLS & DEGAS YOUR
MARKER, DISCHARGING ANY STORED GAS IN A SAFE
DIRECTION, DISCONNECT THE BATTERY & REMOVE THE
BARREL, LOADER & AIR SYSTEM TO MAKE THE MARKER
EASIER & SAFER TO WORK ON.
SLS VALVE GUIDES
FEATURE SUPPLEMENT
5