User Manual

WARNING: IF YOU ARE AT ALL UNSURE OF

PERFORMING THIS MAINTENANCE PROCEDURE

PLEASE CONTACT YOUR NEAREST SERVICE CENTRE. SEE THE

SERVICE CENTRE CHAPTER OF YOUR EGO10 OPERATORS

MANUAL

ADVANCED SL3

INLINE REGULATOR

MAINTENANCE

Fig 3.4

Fig 3.6Fig 3.5

Fig 3.1

Fig 3.3

Fig 3.2

This procedure is only required if your are xing

a supercharging SL3 Inline Regulator (common

symptoms of supercharging are a very high velocity

rst shot and/or large variances in shot to shot

consistency in excess of 30fps).

Place 3/32” hex key through the Adjuster Top (See

Figure 3.1)

, then insert a 1/8” hex key into the bottom

of the Adjuster Screw and carefully turn it counter-

clockwise until the two parts begin to unscrew freely

(See Figure 3.2). With your ngers fully unscrew the

two parts taking care not to lose any of the internal

components (See Figure 3.3).

Inside the Adjuster Screw you will nd a Regulator

Seal, Purge Valve and Spring (See Figure 3.4). Inspect

and clean the Regulator Seal, turning it over if one side

appears excessively worn or damaged or replace if

necessary. Inspect and clean the Purge Valve or replace

if necessary.

Place the Purge Valve and attached Spring in the

central hole in the Regulator Seal (See Figure 3.5), then

insert these parts into the Adjuster Screw.

With the Regulator Seal, Purge Valve and Spring

installed back into the Adjuster Screw, replace the

Adjuster Top (See Figure 3.6). Screw the two parts

tightly together using 1/8” and 3/32” hex keys (See

Figure 3.2)

. Refer to the ‘Cleaning the SL3 Inline

Regulator’ section on page 11 to re-assemble the SL3

Inline Regulator.

FEATURE SUPPLEMENT